we were runing a flywheel that was a lot thicker than the new one i just bought. dont know what the thick one was off of but now with the thinner one we cannot get the clutch to release all the way. we have shimmed the pivot ball out as much as i dare and it just barely releases and the throw out fork is all the way forward against the front of the bell housing clutch hole. i am not sure what is different about the parts we have or what we need to change but would appreciate any help anyone can give us. we changed flywheels because the thick one was all hogged out on the back for weight reduction and the rules are now 20 lb flywheels now and we had to buy a new one from milford motorsports. our throw out fork has a slight curve forward to it but i dont know if that is right or if it should be fairly straight. the trans i the sr4 aluminum 4 speed with the shifter in the top of the tailshaft. it always worked fine before and now it just isnt quite right. PLEASE HELP!!!!!!!!!!! thank you
Bookmarks