01 Rayburn with 05 updates
TURNKEY TURNKEY TURNKEY
Narrowed frame rails
J-bar or Purple bar
BRT Rack with Afco tie-rods
Afco uppers
Outpace Lowers
Rayburn Spindles
Willwood hubs
Willwood calipers, rotors, pads
Aluminum mid-plate
Afco Shocks with Afco Springs
Winters quickchange
Rayburn birdcages
Rayburn fuel cell
Fuel Lines
Willwood master cylinder
gauges
brake bias guages
brake bias adjuster
brake pedal
clutch pedal
gas pedal
shifters
power steering tank lines and pump
(not a nice word)(not a nice word)(not a nice word)(not a nice word)pit and decking
Engine is a 355 small block.
010 bored 30 over 4 bolt main block
Lunati crank
Callies rods
Ross pistons
Bullit custom ground cam
Brodix 11x heads
High rise intake with a holly 850 carb
Assembled at HRE Han(not a nice word)(not a nice word)(not a nice word)(not a nice word) Racing Engines.
Engine dynoed at mullvain motorsports @ 550hp. i have dyno sheets
GM bellhousing
GM flywheel
Bert Transmission
Afco Radiator
Spares= 4 Koni shocks with 8 coilover kits
5 afco shocks
1 lift arm
1 RF Lower
1 LF Lower
2 Hubs with rotors and bearings
3 Pullbars
2 Racks (1 BRT and 1 Appleton) ( Both need rebuilt)
2 Purple Bars
2 Calipers
2 Sets of top rear end plates for pull bar and lay down shocks
8 Springs
4 Swingarms
3 Radius rods with hiems
3 Tie-Rods with hiems
3 Wheels and tires
3 Sets of gears
Plus anything that i find in my garage that goes to the car.
NO BODY.
$9500
twokuhelmotorsports@yahoo.com
309-642-1052 Please call after 430 pm. Thanks Zac
Bookmarks