-
2005 black rocket question
2005 black rocket has two sets of upper a arm mounts on each side, Which holes are people using and what does it do to to raise or lower then?
-
Old post but i am wondering the same thing, anyone know?
-
This is a generic answer...
The upper holes will lower the roll center, the lower holes will raise the roll center.
Semi more complex answer...
On my car when I measured it up, the front view swing arm (measurement from the instant center location to the center of the contact patch) was a bit longer than I feel it should have been when I had the arms in the lower holes, and when I raised them to the upper holes, they were waaay longer than they were supposed to be.
Disclaimer though, my front end has had some repairs on it before I owned it, and while structurally they are ok, I'm not 100% positive the locations of the upper and lower arms were 100% where they were supposed to be.
Having said that, I raced with mine in the lower holes the last couple years, seemed to feel better than when it was in the upper holes. That's all out the window now though, I did some extensive changes to the front, hopefully they are better!
I have a question for the teaming viewers... does anyone have a front suspension software drawing of a black front end? I'd like to compare it to my old one.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT -5. The time now is 09:48 PM.
Bookmarks