Spit a drive shaft few weeks back. Replaced yoke and seal. Noticed leaking. Got under it and noticed that I can move my yoke back forth some. Feels like the input shaft is what's moving. Is this normal? Don't seem right to me but I'm not a rear end guy.
 |
||||||
 |
||||||
|
||||||
|
||||||
|
||||||
|
||||||
 |
Results 1 to 4 of 4
Thread: Yoke on quick change
-
09-11-2013, 08:36 PM #1
Member
- Join Date
- Jan 2010
- Posts
- 60
Yoke on quick change
-
09-11-2013, 10:37 PM #2
Senior Member
- Join Date
- Jun 2007
- Posts
- 796
The newer yokes are about 1/4 inch longer than the old ones. The old ones had a spacer behind the yoke for the yoke to tighten up against. It sounds like you replaced the long style with a short one. You are going to have to get a spacer.
-
09-20-2013, 01:53 PM #3
Senior Member
- Join Date
- May 2007
- Posts
- 477
the spacer fits over the splines so yoke butts against or small diameter between end of shaft and bottom of yoke bore?
To be the man, you have to beat the man!
-
09-25-2013, 01:41 PM #4
Junior Member
- Join Date
- Aug 2013
- Posts
- 28
I had the same issue earlier this season. make sure that you have that spacer or you will be putting seals in every week
Reply With Quote
Posting Permissions
All times are GMT -5. The time now is 04:53 PM.
Bookmarks