Looking for some break in rockers. I really don't want to pull heads apart to only run outer spring to break in a flat tappet cam.
Pre owned that is
 |
||||||
 |
||||||
|
||||||
|
||||||
|
||||||
|
||||||
 |
Results 1 to 7 of 7
Thread: break in rockers
-
12-19-2013, 09:58 AM #1
Senior Member
- Join Date
- Jun 2007
- Location
- LAS VEGAS, NV.
- Posts
- 791
break in rockers
Last edited by DANNY; 12-19-2013 at 10:01 AM.
»»*†HÀ†§ HÓ††™««
-
12-19-2013, 10:26 AM #2
Senior Member
- Join Date
- Jul 2007
- Posts
- 3,224
What are they worth? I have Harland sharps in 3/8 and 7/16 stud.
-
12-19-2013, 11:22 AM #3
Senior Member
- Join Date
- May 2007
- Posts
- 595
What engine Ford or Chevy I have both 1.2 and 1.35 for chevy 7/16 studs and in most cases the heads may have to be machined as the push rod is pushed away from the stud which some times causes clearance issues.
-
12-19-2013, 11:32 AM #4
Senior Member
- Join Date
- Jul 2007
- Posts
- 3,224
Good point on the head clearance. Ive had some motors (oem or eom replacement eq junk) that the pushrod rubbed on the back of the slot or drilled out hole, I used them anyways and figured the rub wasn't enough to increase the pressure at the lifter by much.
-
12-19-2013, 01:08 PM #5
Senior Member
- Join Date
- Jun 2007
- Location
- LAS VEGAS, NV.
- Posts
- 791
It's for Chevy pro topline head, 7/16 stud.
»»*†HÀ†§ HÓ††™««
-
12-20-2013, 12:11 PM #6
Senior Member
- Join Date
- Jun 2007
- Location
- LAS VEGAS, NV.
- Posts
- 791
-
01-04-2014, 02:02 PM #7
Senior Member
- Join Date
- Jun 2007
- Location
- LAS VEGAS, NV.
- Posts
- 791
Still lookin, figure I try one more time if anyone has any they want to sell before I get new ones...
»»*†HÀ†§ HÓ††™««
Reply With Quote
Posting Permissions
All times are GMT -5. The time now is 10:14 PM.
Bookmarks