-
Bert Transmission Rebuild Question
Rebuilding a bert trans, the clutch spacer was pretty chewed up so I am replacing it, the old spacer came off hard, do I need to press new one on? Seems like it is going on pretty tough and looking like the splines will be cutting themselves in on aluminum. I assume this keeps the aluminum from spinning but not for sure. Any advice would be appreciated. Thanks
-
Yes press a new one on, you are correct about the spines cutting themselves in.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT -5. The time now is 10:32 PM.
Bookmarks