Page 1 of 4 123 ... LastLast
Results 1 to 20 of 73

Thread: mustang set up

  1. #1
    Join Date
    May 2010
    Posts
    13

    Default mustang set up

    what is a good base line set up for a mustang running on asphalt. 1/4 mile track tight corners medium banking . spring rates - caster camber and toe . any help would be very much appreciated.

  2. #2

    Default

    We run on a 1/4 mile with tight corners, 18 degree banking. Our baseline is 1 degree left side 2.75 degree right side caster. 4 degree left side camber, 6 degree right side camber. 450 left front, 600 right front, 175 left rear and 150 right rear springs. and adjust from there. 1/8 th inch of toe out

  3. #3
    Join Date
    May 2010
    Posts
    13

    Default

    thank you for the info, what cross do recommend starting with and do pre load the sway bar . also i have conflicting info on which side to put the adjustable link on.

  4. #4

    Default

    Preload is going to depend on what size of swaybar you are allowed to run, atleast I have found that. At the 1/4 mile track we run, the rule says that you must not run any bigger than a stock 1'' bar. The setup that works for us there, is go to neutral on the scale and then preload 2 full turns on a corse thread link. On the other 3/8ths track we race, we can run any stock bar, so we run a 1-5/16th bar with 3 full turns of preload and adjust from there. On the quarter mile we usually end up in the 50.5 to 51 % of cross. Our adjustable link is on the left side.

  5. #5

  6. #6

  7. #7

  8. #8

  9. #9

  10. #10

  11. #11

  12. #12

  13. #13

  14. #14

  15. #15

  16. #16

  17. #17

  18. #18

  19. #19

  20. #20

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

All times are GMT -5. The time now is 10:49 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.