-
A arm lacation advice
Any advice on arm bracket location. Installing 6 inch center tubular arms on metric chassis. Centered ball joint
-
Use upper arm length for camber curve you want at that wheel. Mount upper control arm mount so that it is inline with lower control arm mount from a side view. use software or draw out on paper for the roll center you are looking for.set upper mount at these positions and weld her up. i have done this with stock mounts many times and you can not even tell anything has been changed. makes the car much more consistent!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT -5. The time now is 11:06 AM.
Bookmarks