|
|
-
Lookin for brodix heads and dart block
Looking for a set of Brodix heads and a 400 dart block
-
I have a complete brodix -10 top end that is fresh from the machine shop. Has some new valves, complete valve job, resurfaced the heads, new studs, new valve springs, and new titanium retainers. Heads were ported by Gerte. Have a matching victor jr intake ported by Gerte. Also included is stud girdles, crower stainless roller rockers, and moroso valve covers. All for 1250.00 give me a shout if you are interested. 304 five seven three 8836.
-
-
-
What's your guys location
-
I'm also lookin for 18 or 15 degree heads
-
We are located in Beckley WV. VZ Engines in Gap Mills, WV did the work on these heads. This is the only set of spare heads I have right now but I will keep my eyes open for you.
-
I'm very interested in these set of heads u got let me see if I can get the money for them and I'll get ahold of u in couple days
-
Ok just let me know. You can call me or text me. Sometimes I do not get a chance to get on here so I do not respond give me a call or text. Thanks
-
I have some 18 degree heads and intake shaft rockers valve covers former Joe Gibbs Racing heads
-
what cc are the combustion chambers.
-
-
I have a set of 23º full CNC Brodix Track 1 227cc CNC Heads,
Edelbrock 2925 intake
PBM 30009 roller cam,
rockers
pushrods
I have been thinking of selling
Still on my spare motor.
standard rockers, with stud girdle, nothing exotic, but always been reliable.
has water ports plumbed into intake side and exhaust side of heads
Has about 6-8 nights on head freshen job.
Been ran 2-3 nights a year while primary motor is freshened.
numerous wins and championships when it was my primary engine
also have a Stealth Alky carb I would sell as well that is tuned to this setup.
$1800.00 without carb
$2300 with carb
I think there should be lifeguards in the genepool.
-
I also have a set of fresh Brodix track 1 heads. Fully CNC ported, ported intake to match. Titanium intake valves stainless exhaust valves new Manley springs. T&d shaft rockers, pushrods, lifters,everything in the heads are new less then 50 laps. If interested call me. 662-207-8280
-
I have a Set of 18 Degree Brodix and Jessel Shaft Rockers with 4 Nights on them Fresh from Mullins Race Engines (all new Springs and Valves) Dart 400 Block Bored 40 over Fresh and ready to assemble .. (Over sized Roller Cam Bearings) block has been lightened.... Crower 3.800 Crank (350 Mains) 6" Crower Rods
$3500
Peoria, IL
309-340-3481
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT -5. The time now is 12:18 PM.
|
|
Bookmarks