Results 1 to 3 of 3
  1. #1
    Join Date
    Jan 2014
    Posts
    178

    Default Hub bearing grease

    How much is too little or too much to use in the hubs?

    I run a northern sport mod and I use the DRP grease, seals, and polished bearings.

    I used to use implement grease and I didnt need to grease very often (lol) and i went to this stuff and from what I understood I could get a season out of it.
    I use a syringe to apply the grease and go every-other bearing, sometimes every bearing and put as much in as I can. Then go back over the bearing once more. I rather have too much in there then not enough.

    Just want to know what any one else is doing.


    Pics are after 2 races.
    Attached Images Attached Images
    Just a Sportmod racer at Nelson Boys Racing.

  2. #2
    Join Date
    Dec 2012
    Location
    DeWitt IA
    Posts
    269

    Default

    if your using drp grease every other bearing is all you need . Putting to much grease in adds a lot of drag to the bearings . At mid season take bearings back out clean them and repack that is all you need to do .

  3. #3
    Join Date
    Jan 2014
    Posts
    178

    Default

    I wish my photos would upload on here. I did that plus a little extra and it didn't seem like enough after 2 races. I added a little grease and I'll check it again. I would like to say it's enough but I would hate to junk bearings if I held off till mid season to re-grease.
    Just a Sportmod racer at Nelson Boys Racing.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

All times are GMT -5. The time now is 09:09 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.