Results 1 to 3 of 3
  1. #1

    Default Help finding #1 cylinder miss

    CT 525, #1 cylinder shoots 200-250 degrees colder than all others with heat gun and motor pops and cracks between 2500-3000 rpm,,have changed msd box, wiring harness, coil pack, plug, plug wire, checked compression (150 lbs), took valve cover off and both valves are moving, valve springs look ok,,changed crank and cam sensors,,,checked header for crack,, any ideas?? Checked #1 plug and it is firing
    Last edited by huckleberry_hound; 09-21-2018 at 12:02 PM.

  2. #2
    Join Date
    May 2008
    Posts
    574

    Default

    Sounds like it is just misfiring between 2500-300 and clears up and runs ok in higher rpms?
    Have seen weird stuff from the LS MSD boxes before. I assume that you moved the coil pack from #1 to another cylinder to see if that moves the miss ? Intake runner vacuum leak on #1 ? #1 plug look the same as the others after racing it ? Misfires are compression ( rings/valves ), fuel issue ( usually with injectors ) or a timing issue.

  3. #3
    Join Date
    Jun 2010
    Location
    Santa Land
    Posts
    554

    Default

    What msd box do you have? It it's the old 6010 or 6012 scrap it for the new 6014. They allow individual cyl co trolls for timing.
    My sarcasm is a pre-emptive strike to your stupidity!!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

All times are GMT -5. The time now is 08:55 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.