Results 1 to 4 of 4

Thread: Carb problem

  1. #1

    Question Carb problem

    Running 4412. When car is hiked up and going through corner on the RF as the car is at an extreme angle and g force the car blubbers bad and won’t clear out until 3/4 down straights. How are you guys adjusting floats for this and or what do you do to fix this? Thank you

  2. #2
    Join Date
    Oct 2017
    Posts
    1,361

    Default

    You may have to much fuel pressure. But aside from that a tapered carb spacer if allowed. If not the only real way to combat it is lowering float level. That being said if the first and last thing mentioned are correct it's usually not a problem

  3. #3
    Join Date
    Nov 2007
    Posts
    205

    Default

    I have had the best luck lowering fuel level to a sixteenth or so below the threads in sight glass.

    make sure you have the vent baffle/ extension on there.

  4. #4
    Join Date
    May 2007
    Location
    in a van down by the river
    Posts
    1,892

    Default

    tilted carb spacer
    lower float levels
    tilt motor down in back, and lean motor to left.
    connect the 2 vent tubes with a piece of clear tubing, and make a hole in the top to vent them.
    I think there should be lifeguards in the genepool.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

All times are GMT -5. The time now is 06:49 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.