Some brakes can do it. Other brakes can be adjusted to put a peice of round stock in and bend around i seen one guy that has a deal made up on the side of his sheet metal table just for that. But must of us that don't have that just do like three or four light bends a eighth inch or so apart
What is the best way to get the 1/2" radius (required by rules) on the top edge of the doors, quarters ect?
You don’t, cause no car in the country listens to this rule........ but you could make 4 marks 1/8” apart and just bend it a little, move to the next mark, bend a little more, move to next mark, and so on.
The break I have had a round bar to make bend but might be just me but I usually make the 1/8 inch marks cause they seem stronger and look better.But that's just me.
Bookmarks