thats the way im doing it is cutting the cage inhalf the then put sleves about 1ft or so in the 2 spot where i cut in half its not gonna be half ass done it will hold also im putting in other bars, 1 across behind the driver going from down post to down post at the bottom to the pass side to give more strenght and also the bar that goes across the dash im only cutting 2 spots and im probally gonna put the sleve on then weld the joint then grind smooth then slide the sleves into place and weld i dont think it should be a problem
Bill Seward #25 hornet eaton's auto salvage windsor il 217-273-8728 jims tire service canton il anytime towing 309-338-1935
Bookmarks