I have a brain fart here and trying to get thru it. The car when I last raced was a good setup and worked good. Now 7 months later I finally got out to race again but the track added some new clay. Now the car developed a push thru middle and I have to break it loose and loose turn speed and some drive.
This is a 3 link solid pull bar with Impalla clip RF= 750 LF= 800 RR= 150 LR= 225 No Floaters..
Here is my thoughts.
1- Take 30lb weight off RR up frame bar
2- Raise pinion 1 whole up/ or drop frame side down 1 inch...
3- Raise RR bar 1 whole.
All of which is gonna effect my drive off I think.
Any BETTER IDEAS or which should I try.
Entry is real good in main and the heat race I can stand on it and just throu it and go. MAYBE a little pushy in the heat in middle but I said maybe I was rusty...
Thanks guys.
Bookmarks