Looking for a tubing bender

**missile07** · 10-01-2012, 02:24 PM

Looking the purchase a used tubing bender. I would prefer to buy one similar to the Speedway or Allstar upright design with 1.25"-1.75" dies.

Let me know what you have....cash in hand

**missile07** · 10-03-2012, 07:28 AM

Still looking

**BMR** · 10-03-2012, 07:19 PM

Call Jamie Johnson. He's in London,KY. He has one with 4 sets of dies (I think) for sale. Tell him Cecil told you to call. 606-309-9627

**dirtmod91** · 10-04-2012, 10:53 PM

Still looking?

**missile07** · 10-05-2012, 09:35 AM

Yes check your Pm

**missile07** · 10-17-2012, 03:16 PM

Seller backed out....still looking!

**missile07** · 10-19-2012, 09:42 AM

Looking to buy a used one but thanks for posting

**NRP** · 10-19-2012, 11:29 AM

Have a barely used one.

call .812.361.9743.

**missile07** · 10-19-2012, 01:55 PM

Just looking to buy a used smaller hydraulic style. Would prefer a 1.5 die but would be open to options on dies.

Not planning on building cars or roll cages just a few bumpers when needed.

**racin87** · 10-20-2012, 03:02 PM

http://www.ebay.com/itm/1-1-2-Roll-C...item257246c998

**missile07** · 10-20-2012, 03:29 PM

87,

I like those Affordable bender and I have talked to them a couple times about it. They said with anything less than .90 it would kink & ripple the bends. Not that it would hurt anything on bumpers cause sometimes that don't last a full night.

Stock,

We dont have bumpers around here for that kind of money....but it doesnt make since to me to spend $700-800 on a bender with one die and to build bumpers. Some seasons we may go all year without messing up a bumper...this season we bent 2 fronts & 1 rear in one night.

Again still looking....its just a little personal project for the winter