|
|
-
2008 Rayburn complete roller **SOLD**
2008 Rayburn full roller, swing/Z, typical Rayburn equipped with Winters 4.86 rear, Sweet rack, Wilwood hubs, Koni's on front. Comes with 2 full sets of wheels (1 set Weld, 1 set Valken), all tires (WRS-2's, couple LM40's, 1 new D-55 not mounted) are 75% or better. Also comes with BERT trans, Brinn mag bell and Brinn starter, almost new steel driveshaft, Kirkey seat, fresh KSE tandem pump with new power steering section (nearly $400 rebuild by KSE, with paperwork), 2 new (2 races only) AFCO threaded body shocks with new coil-over kits and new springs on the rear, 5 sets of gears, loading wheel for narrow trailers. Lazer Lid 'glass roof, 2 races on new nose and fenders with fresh sheet metal on the front and right side.
Car is all black with black chassis and black-on-black sheetmetal, has Rayburn purple spindles, standard J-bar, short pull bar, and will only need your engine and headers to race. Comes with some spares like upper A's, 4 extra Koni's, couple extra springs, extra swing arms, extra rotors, etc. Everything I have for this car goes with it.
Picture is of how the car sits right now, was taken Sun Nov. 11, 2012. Asking $6k for the complete roller, or $4500 minus the trans, bell, starter, and KSE pumps. Call Brookin Stephens @918-436-9882 Mon-Fri or PM here.
Last edited by wishiwasfast; 01-07-2013 at 07:06 PM.
Reason: change title
-
-
Is this a combo car or swing arm zlink only?
-
Not a combo car. Also, the folks I got it from said it was originally built for Dan Schleiper.
-
Will take $4000 minus the drivetrain and KSE pumps, everything else goes.
-
Originally Posted by wishiwasfast
2008 Rayburn full roller, swing/Z, typical Rayburn equipped with Winters 4.86 rear, Sweet rack, Wilwood hubs, Koni's on front. Comes with 2 full sets of wheels (1 set Weld, 1 set Valken), all tires (WRS-2's, couple LM40's, 1 new D-55 not mounted) are 75% or better. Also comes with BERT trans, Brinn mag bell and Brinn starter, almost new steel driveshaft, Kirkey seat, fresh KSE tandem pump with new power steering section (nearly $400 rebuild by KSE, with paperwork), 2 new (2 races only) AFCO threaded body shocks with new coil-over kits and new springs on the rear, 5 sets of gears, loading wheel for narrow trailers. Lazer Lid 'glass roof, 2 races on new nose and fenders with fresh sheet metal on the front and right side. Car is all black with black chassis and black-on-black sheetmetal, has Rayburn purple spindles, standard J-bar, short pull bar, and will only need your engine and headers to race. Comes with some spares like upper A's, 4 extra Koni's, couple extra springs, extra swing arms, extra rotors, etc. Everything I have for this car goes withPicture is of how the car sits right now, was taken Sun Nov. 11, 2012. Asking $6k for the complete roller, or $4500 minus the trans, bell, starter, and KSE pumps. Call Brookin Stephens @918-436-9882 Mon-Fri or PM here.
Where is the car located?
-
-
Car is in eastern Oklahoma.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
All times are GMT -5. The time now is 10:46 AM.
|
|
Bookmarks