2008 Rayburn complete roller

[wishiwasfast]

2008 Rayburn full roller, swing/Z, typical Rayburn equipped with Winters 4.86 rear, Sweet rack, Wilwood hubs, Koni's on front. Comes with 2 full sets of wheels (1 set Weld, 1 set Valken), all tires (WRS-2's, couple LM40's, 1 new D-55 not mounted) are 75% or better. Also comes with BERT trans, Brinn mag bell and Brinn starter, almost new steel driveshaft, Kirkey seat, fresh KSE tandem pump with new power steering section (nearly $400 rebuild by KSE, with paperwork), 2 new (2 races only) AFCO threaded body shocks with new coil-over kits and new springs on the rear, 5 sets of gears, loading wheel for narrow trailers. Lazer Lid 'glass roof, 2 races on new nose and fenders with fresh sheet metal on the front and right side.

Car is all black with black chassis and black-on-black sheetmetal, has Rayburn purple spindles, standard J-bar, short pull bar, and will only need your engine and headers to race. Comes with some spares like upper A's, 4 extra Koni's, couple extra springs, extra swing arms, extra rotors, etc. Everything I have for this car goes with it.

Picture is of how the car sits right now, was taken Sun Nov. 11, 2012. Asking $6k for the complete roller, or $4500 minus the trans, bell, starter, and KSE pumps. Call Brookin Stephens @918-436-9882 Mon-Fri or PM here.

[wishiwasfast]

back up top.....

[nofearracing]

Is this a combo car or swing arm zlink only?

[wishiwasfast]

Not a combo car. Also, the folks I got it from said it was originally built for Dan Schleiper.

[wishiwasfast]

Will take $4000 minus the drivetrain and KSE pumps, everything else goes.

[racerx13]

2008 Rayburn full roller, swing/Z, typical Rayburn equipped with Winters 4.86 rear, Sweet rack, Wilwood hubs, Koni's on front. Comes with 2 full sets of wheels (1 set Weld, 1 set Valken), all tires (WRS-2's, couple LM40's, 1 new D-55 not mounted) are 75% or better. Also comes with BERT trans, Brinn mag bell and Brinn starter, almost new steel driveshaft, Kirkey seat, fresh KSE tandem pump with new power steering section (nearly $400 rebuild by KSE, with paperwork), 2 new (2 races only) AFCO threaded body shocks with new coil-over kits and new springs on the rear, 5 sets of gears, loading wheel for narrow trailers. Lazer Lid 'glass roof, 2 races on new nose and fenders with fresh sheet metal on the front and right side. Car is all black with black chassis and black-on-black sheetmetal, has Rayburn purple spindles, standard J-bar, short pull bar, and will only need your engine and headers to race. Comes with some spares like upper A's, 4 extra Koni's, couple extra springs, extra swing arms, extra rotors, etc. Everything I have for this car goes withPicture is of how the car sits right now, was taken Sun Nov. 11, 2012. Asking $6k for the complete roller, or $4500 minus the trans, bell, starter, and KSE pumps. Call Brookin Stephens @918-436-9882 Mon-Fri or PM here.

Where is the car located?

[racerx13]

Where is the car located

[wishiwasfast]

Car is in eastern Oklahoma.

[wishiwasfast]

SOLD. Thanks 4m.