Good evening, racers:
I am going to use an oil cooler on my wet sump SBC in my old pavement late model turned road racer.
I have looked into sandwich adapters and I like the Canton piece.
My questions are:
If the adapter has 1/2" fitting holes, is there any benefit to going bigger than -10 hoses (-10=5/8" ID) ?
Where is the best option for mounting? I could put it in the tunnel with a NACA duct from the right A pillar, but would have to go up and over the exhaust system.
Is there enough air flow if it is just mounted in the tunnel?
As usual, I welcome any and all opinions. If anyone has any photos of installations, I would very much like to see them.
Cheers,
RR
Bookmarks