I have a b mod chassis that was suppose to go the chassis builder to get checked, but I can't get a hold them. I need to start putting this car back together so I was wondering if there is a way to measure the front end to see if it's straight. I know this is a hail Mary, but any help would be appreciated. Thanks
2012 UMP Stock Car National Champions.
2013 UMP Modified Rookie of the Year
2014 Kankakee Speedway UMP Modified Champion
2016 Fairbury American Legion Speedway UMP Modified Champion
2016 Kankakee Speedway UMP Modified Champion
2016 UMP Modified, Northen IL Regional Champion
2018 UMP Modified, #2 National Points Standings
Like us on Facebook, https://www.facebook.com/McKinneyMotorsports
here is how i checked mine it might help you some start with a plung bob get car level start at mid plate mark a spot on the floor on each side of the plate were it bolts up . now go to front of car use bob come off the lower a arm ball joint grease insert mark a dot on the floor on both sides . then goto rear end and do the same off the front of rear end axle tubes now draw a line from dot to dot now measure and see if any thing is out should be the same from on both sides that how i square up my car hope this helps
Bookmarks