proper way to install a high cc head on a zero decked block 2700

[pilotracer]

Zero decked 30 over 2700 bottom and a high cc size head roller that's shaved to intake bolts arp studs 27 though cosmetic I need the proper way to install and torque specs 34 degrees timing cam straight leveled and octane to run cause 110 would sometimes stay running after off like bad gas just trying to get a idea if I am doing something wrong

[car62]

well i believe your ignition timing is too low,id probably start out at no less than 36 degrees.

[pilotracer]

Race engineering tech said same I was always told no more then 34 on 5.7 so maybe bump up and jet accord to keep kool still looking for octane 110 ok and 90 psi torque on arp studs ok?

[car62]

thats not true,we have found great power in the 38-39 degree range...110 should be fine and yes 90lbs

[pilotracer]

Thanks took care of problem so far