Over the winter I purchased a 2012 Blue Rocket that had been updated in 15’ to the new style. Coming from an older Black rocket, I had extra racks sitting around (Woodard). I ordered the combo shaft from that has both the 18 ¼ and 19 ¼ holes and installed with new bushing myself. When I assembled the car the only way I could set the RF tie rod to the rocket book spec was to have the RF outboard (+1”) and the tierod in the 18 ¼” position. When I did set it that way I could get everything to measure out but cant more the RF back inboard without throwing off the rf tierod measurement. Has anyone else ran into this? When I bought the car it was a bare chassis and I put new front suspension components per the book except the rack. Any help here would be appreciated, thank you in advance.
Bookmarks