Search:
Type: Posts; User: Racingtech
Search:
Search took 0.68 seconds.
-
Moldymundoon is 100% right that will work
-
On the left rear it keeps the tire loaded when the car rolls over, if your spring is short and it rolls up and off the spring you have no bite untill the car transfer's the weight back to it.
-
I have seen bell housings that didn't line up the trans straight with the engine. Good luck
-
How much? Is it a full frame?
-
If you Listen to Stock car Driver, and read his posts on springs and rates you will be on the right track.
-
The piston needs to come out far enough for brakefluid to be behind it or you wont have good pressure on your pads
-
Does anyone know what gears ratio the modified street car run at tazwell tenn. Its high banked and one third of a mile.
-
Fuel burning in the exhaust can cause the exhaust to glow. How it gets there can be caused by several things, To rich , miss fireing, if you are running a HEI ign, check your coil they can overheat...
-
If you are talking about a sbc 400.
-
I don't think its right to advertise a race to be 30 laps and then only run 15. With all the expense that it takes to get to the track and race, we should be able to run the full race. If a fast car...
-
I was there last night and I think Joey and Tiffany did a great job. Alot of things happened that were beyond thier control but were handled the best that anyone could have. I was sitting in the pits...
-
I have used the plastic fan for years with no prblems even on hot days. You have to have a good shroud and space it up close enought to the radiator. I have had the metal steep pitch 4 blade pull the...
-
I have a sbc block that is right side dipstick, 80 to 86. It was a factory roller block. My question is what roller lifters would I need to use with a small base circle cam in this block.I am...
-
I'm not disagreeing with anyone here but I have a 355 that has sir rods in it and it has seen 7600 plenty of times and it was built in 2007, still going. from what you are saying it doesn't sound...
-
I had the same problem. Get a victor reinz seal # jv1603 made for line bored engines. It solved my oil leak in a 406 race engine. Good luck
All times are GMT -5. The time now is 10:44 PM.