Fresh Built 355 Chevy R.A.T.S. Racing Engine

[R.A.T.S. Racing 33]

Fresh never run Street Stock racing engine, its an 010 4 bolt block bored .030 over with .020 piston to deck, #2442 GM cast crank, GM Pink rods, Clevite bearings, DuraBond flyweight balancer, Silvolite hypereutectic flat top pistons, moly rings, Tru roller timing chain, fully balanced rotating assembly. Heads are #462 double hump Chevy 58cc chamber with Manley 2.02 int and 1.60 exh stainless steel valves, Crane springs good to .550 hydraulic flat tappet lift, machined steel retainers and locks Crane GOLD roller rockers with polylocks, screw in studs and guide plates, chrome moly pushrods, PBM hi rev lifters. Has an Edelbrock 2101 intake, tall valve covers with breather tubes, 7qt circle track oil pan with one piece rubber gasket, Melling M55HV oil pump and pick-up with hardened pump shaft, lightweight chrome moly fuel pump push rod. Will provide a new cam for your application. Can provide pics of engine during build, contact me with any questions. 540-389-8400 or email rats_racing@yahoo.com if no answer please leave a message and I'll return your call ASAP! Very nice engine asking $3500 OBO

[R.A.T.S. Racing 33]

Back to the top.......

[R.A.T.S. Racing 33]

Back to the top........

[R.A.T.S. Racing 33]

Back to the top......

[R.A.T.S. Racing 33]

Back to the top.....

[R.A.T.S. Racing 33]

Back to the top......

[R.A.T.S. Racing 33]

Back to the top......

[R.A.T.S. Racing 33]

Back to the top.........

[R.A.T.S. Racing 33]

Back to the top.......

[R.A.T.S. Racing 33]

Nice new engine!!!

[R.A.T.S. Racing 33]

Bump.............