wtb? looking for?

[dirtdodger]

Quickchange? 60"with 2"offset. Gauges shifters tranny, 400 or larger sbc or sbf engine, pull bar or lift bar for 2012 pierce. Pedals with cylinders. Most everything needed for mod. Let me know what u got

[59evans]

Quickchange? 60"with 2"offset. Gauges shifters tranny, 400 or larger sbc or sbf engine, pull bar or lift bar for 2012 pierce. Pedals with cylinders. Most everything needed for mod. Let me know what u got

we have everything u need call chad at 2172348859

[april509]

Have everything u need. 28' inclosed trailer, 2007 laser chassis, 2011 lightning chassis,383 roller motor, scales, two Bert transmission. So much more. Selling out. Finished 9th in eldora points 2013. No junk $12000 firm. Call Ford more info. 937-three44-749one.

[dirtdodger]

i have a car just looking to complete it. i have a 2012 pierce with (not a nice word)(not a nice word)(not a nice word)(not a nice word)pit, seat, fuel lines, fuel cell, front suspension, also have a 9" rear end but would rather get a quick change, power steering pump, steering quickener, steering shaft, and wheel.

[circletrackjack]

have everything what is your phone #
812-453-3003 located chandler,in

[59evans]

WE have everything you need we just stripped are 2013 pierce and went to an impressive so let me know ive got an entire car minus the frame sitting in the shop in mattoon ill chad 2172348859 or jd at 2172593579

[dirtdodger]

i have an msd box, complete front suspension, steering components, have a 9" rear with all brackets except for 1 caliper bracket that also needs axles but would like to get a reasonobly priced quick change, seat, fuel cell with lines, might have motor,

i need tranny, still looking for motors though, gauges, shifters, linkage, brake/clutch pedals with cylinders, gas pedal, switches, swedge tubes, pull bar or would like to go with a lift bar setup, j-bar and mount, battery and charger, quick change, drive shaft, radiator, resevoirs, would also like to get bearing bird cages, brake bias controller, swedge tubes, ballast/lead mount, chain limit mount, rear brake calipers, if no quick change will need winters hubs, axles, and 1 caliper floater bracket, and anything else i may be forgetting. have an extensive late model background so might not have it all listed if you can think of anything else.

let me know what you got with a price on it and will see what we can work out.

[bob75]

dirtdodger, evans 59 has what you need call him.

[59evans]

we got a complete quick change with everything on it all we did was unbolt the bars un hooked the brake lines and the pull bar lift bar and the biskit is still all together give chad a call for the price 2172348859