Old Winters rear ends

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • over4T
    Senior Member
    • Feb 2015
    • 1112

    #16
    Don't remember much about the quality of the old Winters but you couldn't do better than an old Frankland. I've still got one from 1985 that I've never had anything break on. Been sitting behind the barn in my old torsion bar front/ coilover mono leaf car for near 20 years and could probably change the gear oil and run it again.

    Wouldn't have a Winters if their QC is the same quality as their 9" floaters. The 9" is cheap crap.

    R.I.P. Jim Frankland

    Comment

    • Rocky
      Senior Member
      • Jul 2007
      • 3218

      #17
      One of them is in running condition. It developed a seal leak out of the left Bell this season but still works. The other one, I don’t know.
      Guerilla Racing Junkies.

      Shovel on a little more coal, then when we cross white oak mountain, watch 97 roll!

      The problem is the gall dang motors.

      Comment

      • fastford
        Senior Member
        • Dec 2008
        • 4059

        #18
        Originally posted by over4T View Post
        Don't remember much about the quality of the old Winters but you couldn't do better than an old Frankland. I've still got one from 1985 that I've never had anything break on. Been sitting behind the barn in my old torsion bar front/ coilover mono leaf car for near 20 years and could probably change the gear oil and run it again.

        Wouldn't have a Winters if their QC is the same quality as their 9" floaters. The 9" is cheap crap.

        R.I.P. Jim Frankland
        there is not much difference , that old frankland center i mentioned has a winters bell on the left side...

        Comment

        • dirtcrazy4u
          Senior Member
          • Feb 2017
          • 3212

          #19
          Yea and when ferree bought Franklin they went downhill quickly

          Comment

          • Krooser
            Senior Member
            • Nov 2012
            • 3117

            #20
            I bought a Frankland mag center with aluminum Winters sidebells. Didn't like the mix and match deal so I sold the Winters bells and found two used Frankland mag bells from a guy on FB.

            Bought a few things from him and he was always good. Now I'm sitting w/o bells since he decided to leak out and he never shipped the bells.

            Got PayPal out after him . If they don't refund my money I'm taking a road trip to Peoria with a couple goons with baseball bats.
            Member of the Luxemburg Speedway Hall of Fame
            Class of 2019

            Comment

            • Illtsate32
              Senior Member
              • Jun 2015
              • 3079

              #21
              Originally posted by over4T View Post
              Don't remember much about the quality of the old Winters but you couldn't do better than an old Frankland. I've still got one from 1985 that I've never had anything break on. Been sitting behind the barn in my old torsion bar front/ coilover mono leaf car for near 20 years and could probably change the gear oil and run it again.

              Wouldn't have a Winters if their QC is the same quality as their 9" floaters. The 9" is cheap crap.

              R.I.P. Jim Frankland
              We had one too, the cover on it look like a bell kinda, or a ten gallon hat...

              Comment

              • doyle hargraves
                Senior Member
                • Jul 2009
                • 158

                #22
                Those old rear ends with the deep cover were the standard until the late 80’s what we all have now was referred to as a “sprint center” when they first started being used in the early 90’s

                Comment

                • Rocky
                  Senior Member
                  • Jul 2007
                  • 3218

                  #23
                  The new car (did I just admit that publicly) has a new style rear end. So yeah I suppose I have been running a rear end from the Reagan administration. Still a lot of them in Sportsman cars around here.
                  Guerilla Racing Junkies.

                  Shovel on a little more coal, then when we cross white oak mountain, watch 97 roll!

                  The problem is the gall dang motors.

                  Comment

                  • Illtsate32
                    Senior Member
                    • Jun 2015
                    • 3079

                    #24
                    Yes that old Frankland aluminum cover you had to be careful tightening the bolts they were long and skinny and would snap off...my Dad had to drill out more than one of em lol he wouldn't be too happy with me...

                    Comment

                    Working...
                    X