Fayetteville Motor Speedway, NC

[DoubleZero]

New FB page: https://www.facebook.com/fayettevillespeedwayofficial/

[SLIPPING SIDEWAYS]

Have a WoO LM date later in the schedule.

[SLIPPING SIDEWAYS]

Says they're hinting at a reconfiguration

[Lucky13]

Talked to the new promoters today. I am looking forward to next year.

[Mason87]

I was told today about the reconfiguration and I must say I'm excited about. These guys really seem like they are gonna back up their talk.

[Barbecueboy]

Send a drone over Dublin......take measurements......copy it.

Can't tell you how many times I've heard over the years......man if Dublin had fayettevilles facility or Fayetteville had dublins track this place would be perfect.

Sounds like now might be the best chance to make that a reality.

[DoubleZero]

Fayetteville's straights are longer, but its turns are tighter than Dublin.

[dirtSLMracing]

Mason..

Any idea what type of reconfiguration they are discussing?

[Mason87]

Check your messages dirtSLMracing

[Barbecueboy]

Fayetteville's straights are longer, but its turns are tighter than Dublin.

If what I'm hearing is correct.....not for long.

[Mason87]

Clear your messages barbecueboy

[DirtPhantom]

Was told the new promoters are planning to reconfigure the track into a 3/8th mile oval with wide high banks on both ends wich should improve the racing greatly.

[HIGH ROLLER]

Was told the new promoters are planning to reconfigure the track into a 3/8th mile oval with wide high banks on both ends wich should improve the racing greatly.

That would be kinda like friendship speedway right.

[edavis71]

My luck there has always been terrible, semi-long drive to get there, bad luck and a long drive home... Always appreciated the people as I said, did have quite a bit of fun on some of the two day shows back in the day...Haven't been in probably four years.

Had a good time a few times there till we ran outta beer. Fill it with water and stock it with fish!!!

[Barbecueboy]

That would be kinda like friendship speedway right.

Screven is 3/8 with wide-ish turns....