If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Nobody really "knew" what they were doing. Was changing every week. Spring bars abounded! See the Right upper bar? They had springs on about everything.
Nobody really "knew" what they were doing. Was changing every week. Spring bars abounded! See the Right upper bar? They had springs on about everything.
Those made a comeback in 2015. They were made illegal during the Rumley rules. There's people who think they are worth 0.2 second. But they really aren't worth anything unless they change the balance of the car for the better. Putting it on the rr upper will tighten a car up for sure. I used them with success in the 90s.
Those made a comeback in 2015. They were made illegal during the Rumley rules. There's people who think they are worth 0.2 second. But they really aren't worth anything unless they change the balance of the car for the better. Putting it on the rr upper will tighten a car up for sure. I used them with success in the 90s.
Like to know the weight difference of that car vs new one. How much lead did it carry & what was the spec? Is that particular car one of the undercover Rockets?
Mark Richards was a Bullitt dealer, he had some changes he wanted to try and convinced Ray Callahan to build him 3 chassis to his specs. These were the first 3 Rockets. I can't say if a Rocket is based on a Bullitt, but I'm sure Mark took what he learned selling and wrenching Bullitt's to come up with what he wanted to try. After the initial 3 Ray wouldn't build him anymore so Mark struck out on his own. I guess you could say the first 3 were built with "Bullitt" hands...
"In the Republic of Mediocrity, Genius is Dangerous." - Robert Green Ingersoll
I had a watts link Rayburn (maybe '84 car) that the right rear upper bar was spring loaded; built for extension instead of compression so it would shorten the right side wheelbase on exit like the springrod above.
I had a watts link Rayburn (maybe '84 car) that the right rear upper bar was spring loaded; built for extension instead of compression so it would shorten the right side wheelbase on exit like the springrod above.
Comment