bowtie aluminum heads 10051101

[super trucker]

Can any one tell me about these heads?

I have found they are 55cc with 196 intake runners with 2.02 valves that need to be .100 long. What I need to know is, are they 23* heads and what rocker arms do they require? Do they need to be offset? What length push rods?

Any help would be appreciated.

Thanks

Rob

[Captain Happy]

That's what she said!!

[W2Racing09]

That's what she said!!

Really? You are worse than Litey or Keith ever thought of being.

Thanks,
Jeff.

[Punisher88]

Are you asking about the brodix NLMS spec heads? If so if you give me your email I can send you all the info I got from brodix.

[powerslide]

With that small of a runner and 2.02 valve I would think they are 23 degree heads and probably take standard SBC rockers. Pushrods depends on how much the heads and block have been milled. They may of been rolled to 21-22degrees with the smallish chamber.

Might try the question here over here in the natural aspirated section
yellowbullet.com they have a lot more motor knowledge then anyone here.