Is this cost saving?

[zyoung25]

I am one of those people that believes the pull down rig is of limited usefulness, but Bloomer is in the infancy of using it. So who knows?

I talked to a guy last night that said the same thing as you say here. He said these things arent as useful unless a guy has the time and know of these high dollar data acquisition deals. Which then a guy needs to do a lot of testing.....again more money.

[old fan]

some people (bloomer) work for what they have, and others pull the slipping jimmy routine on st. Louis sidewalks when they're not posting 300 times a day on here dogging someone else's success.

yep cheat your way thru life its the american way and far as the sidewalk well if somebody would 've done there job there wouldn't been says the lawyer for st louis city

[dirtdobber45]

Dyno must be working... wup those woo boys last week and swept em in ohio this week

[Krooser]

I thought a pull down rig was an oak tree and a port-o-power...

[MI Dirt Fan]

I thought a pull down rig was an oak tree and a port-o-power...

Still is. Believe me. We've done that somewhat recently. Sometimes you also have to start it up and use reverse also. Lol

[racingfool32]

Tommy Hicks tweeted the pic.

[huskerdirt]

Tommy Hicks tweeted the pic.

The fake one... not the real one.

[MI Dirt Fan]

I think the original poster Davis(something) is just trying to stir the B.S. I saw in the archives him doing the same thing about something else with Bloomer.

[Krooser]

MDF,

We must live on the poor side of town... across the tracks... down in the boondocks.

[hotshoe65s]

As someone who works with push up rig (cup team's version of a pull down rig) and 7post on a weekly basis, I can tell you that I see nothing special going on there. It looks like nothing more than a surface plate and some scale pad stands. He is just using a surface plate to get everything as level and accurate as possible. Then he has some lasers it looks like to get alignment measurements. I don't see much for hydraulics going on in the picture. And if you were doing a pull down work you would want your scale pads mounted where they couldn't move. Those pad stands are just sitting on 6 pedestals like every cup team uses at the track each week, they are free to move around.

[MI Dirt Fan]

MDF,

We must live on the poor side of town... across the tracks... down in the boondocks.

lol. I live in town. He lives out in the boondocks where no one would see.
A couple chains, a porta power and a come along. Sit back and watch the magic.

[Wonder]

Pierce doesn't have a calibrated surface plate, dyno or a pull down jig and he wins races. He does have a port-a-power! LOL

[chupp n bloomer fan]

Wow....you guys would really get yer panties wadded up if you knew top teams are also spending time in wind tunnels! Because they are.

They've been in the wind tunnel for over ten years. Randle Chupp, Bernheisel, were two of the first I knew of.

[jog49]

Some of the resident blowhards on 4M provide the hot air for a number of wind tunnels! LOL!

[Bubstr]

Seems a lot of people want to make something exotic out of a pull down rig. All they are is a way to put side force on your center of gravity and scales to read the difference in wheel weights, while doing this. This, if used right, can tell you the balance of a car at any degree of a corner or even straight a way. It can tell you the changes in balance, with higher or lower center of gravity. Just like any other tool, they are only as good as the person using it. This is nothing new. Drag racers where using something similar as far back as the late 60s to get equal traction on the rear wheels.