If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Switched to 604 from open aluminum motor, using same midplate sets 604 too low in rear, when spacing the motor mount to get fan clearance, motor has too much angle,,, do 604’s use different midplate?
Not sure what car you have but in a Rocket most run 1" spacers under the front motor mounts and the midplate has two sets of holes to allow it to also be raised 1".
Tweet
Comment