Bert Ballspine Trans Clutch Bleeding

[DLMDRIVER25]

I have a ballspline transmission, and I see where the line goes from the master cylinder to the trnasmission, but I dont see a bleeder screw anywhere on it. Can someone post a picture or something to show me where this thing is supposed to be bled from?

Thanks,

Stephen

[Egoracing]

I have a ballspline transmission, and I see where the line goes from the master cylinder to the trnasmission, but I dont see a bleeder screw anywhere on it. Can someone post a picture or something to show me where this thing is supposed to be bled from?

Thanks,

Stephen

It is a plug not a bleeder screw like the brakes.

[DLMDRIVER25]

Okay, I see that. So I just let it gravity bleed with the plug out and when all the air is out put the plug back in?

[Egoracing]

Crack the plug and let it bleed several hours, this will not get all the air out but it will get a majority of fluid in the line. Then bleed as you normally would bleed the brakes. I have had to take the line off the master cylinder before and fill it with fluid using a syringe with the plug loose then put it back on the master cylinder and then bleed it.