Mastersbilt Serial Number Identification

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Dirt36
    Senior Member
    • Jun 2007
    • 141

    #16
    Easiest thing is to post a pic of the 4 link brackets. My first LM was a 2000 Mastersbilt and it had single sided brackets on it from Masters. I believe the warrior cars from that era were double sided, but I am not a warrior expert I have just been around a couple of the early 2000s cars.

    Comment

    • Dirtracer#44
      Junior Member
      • Dec 2014
      • 2

      #17
      I'm new to this where are the 4 link brackets is that in the rear

      Comment

      • TheJet-09
        Senior Member
        • Jul 2013
        • 1616

        #18
        Yes, in the rear. They are where the links that connect to the birdcages/rearend attach to the chassis. There should be a mount on each side at the bottom, off the frame rails, and a mount on each side higher on the chassis, say slightly lower than shoulder height if seated in the car. If it only has mounts on the bottom, but also has mounts back by the fuel cell area, it could be an old swingarm car or even an older monoleaf car.

        Comment

        Working...
        X