Brake Bias

[bigk44]

Problem I am having is I can only get the rear 50# less than the front.

What is the correct way to set up? Should you start with the rods out of master cylinders even?

Thanks,

Kevin

[Len72P]

Go to Tilton racing site and then tech. Installation instructions , you will find details on how to correctly setup your bias bar. Also make sure you have 18 to 20 turns of adjustment. I bought a new adjuster, with sliding indicator, and it would only go 14 turns until the indicator bottomed out. Could not get enough rear brake.

[bigk44]

Go to Tilton racing site and then tech. Installation instructions , you will find details on how to correctly setup your bias bar. Also make sure you have 18 to 20 turns of adjustment. I bought a new adjuster, with sliding indicator, and it would only go 14 turns until the indicator bottomed out. Could not get enough rear brake.

That might be the issue. I only have 12 turns. I need to check which side the long threads are on.