Tweet
Does anyone have any baseline measurements for this car. The setup I can do but looking for ride heights and things like rear end lateral location measurents. I had Carl Billets number but unfortunately didn't realize he passed away I've never worked on one and a client is trying to get his feet wet before he upgrades some stuff I can rough in but need to know he has at least the right components.
-
-
Come on I have faith Magnum Chassis would work as well I believe -
-
Ok I will as soon as I can who will I be speaking with?Comment
-
I might be able to help you out.... I've been running them since '99Comment
-
springs: 550LF, 450RF, 250LRB, 225RR
Ride Heights: 3 7/8" LF and RF bottom of frame rail to top of lower
Ride Heights: 10-10 1/2" LR and 9" RR bottom of frame rail to top of axle tube
Rear end set 12" from inside edge of rear over rail to edge of bell
set rear lower bars to 16" center to center of heim joints both sides
upper bars will be roughly 18' center to center, but adjust to index birdcages squarely
i ran about 180lbs LR back then, but the low wedge stuff should work too (toted the LF very high in those days)Comment
-
By edge of the bell do you mean 90/10 plate or what's your definition of Edge of bellComment
Comment