Tweet
You could use round as well its just square is much easier to drill I don't know about 2 in though you can't drive that bad LOL. I was drilling a hole in front bumper for nose should have drilled from back thru nose dummy here knew better and drilled it from front missed center of tube making a nice slot in a new md3 nose .
-
Last edited by RW57; 02-11-2016, 05:10 PM. -
It seems that every time I buy something new I'm always the first to dent, ding or break it.Member of the Luxemburg Speedway Hall of Fame
Class of 2019Comment
-
Naw... just funnin' you. But I DID have a sportsman car around 1970 with a 6" well casing front bumper...Member of the Luxemburg Speedway Hall of Fame
Class of 2019Comment
-
I run a piece of 1 inch x1/8 aluminum angle down the length of my sides. From firewall brace back to spoiler brace. Gives it just a little rigidity when someone is leaning on or pushing.Comment
Comment