If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
how can you tell if your heads will except more lift than stock and is there any alternatives instead of machinig the block. I heard if you run beehive springs you don't have to worry about machinig the heads. Is this true
Beehives are small dia. base, so ur good on not machining.. Do cut theheight on the valve seals down though.. you get too much lift and the retainer will hit and cause all sorts of malfunctions.
Tweet
Comment