If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Looking into using a buddy's clutch for a big race. Jw if the crank bolt holes need to b re tapped bigger for a gold star clutch as ill b going bk to a stock set up after the race.
NO unless someone has drilled the goldstar for 7/16. You can drill your stock flywheel and tap to 7/16 x 20 thread and use regular chevy stuff. You'll be much better off in the long run. You need a good ARP bolt in any flywheel.
Tweet
Comment