I have the left side one inch higher than the right. The car is not getting much side bite on a track that's hard to get ahold of.
How much tilt?
Collapse
X
-
Need all the information on how the car is currently setup and what type of suspension is on the car. JMO
-
Comment
-
I don't know the exact wheel weights but we've ran 30-80 lbs lr bite just trying to make it better but normally try to get 60 at all times. Rf 3-12 rr 3-5 lf 6-2 lr 12-2. Three inch offsets very where but rr has a 4 rr is trailed a 1/4 inch. Has about 1/2 inch stagger in front and 1-1/4 in rear. Rf ap 14 rr12 lf 12 lr 10
Comment
-
One more thing. How are you entering the corner? Driving right to corner and letting off or letting off slightly way before corner? Are you entering corner down low or are you keep car straight by entering up a groove or so? JMO
Comment
-
Forgot to ask what size, type and banking on track but I would try dropping ap to rf13 rr12 lf10 lr8. Reset wedge after dropping pressures.put a 2 off on LR and raise jbar on frame 1 inch. Normally I would only make one change at a time, but these changes should tighten car all the way thru the corner. If car still drives the same it is probably a driver issue. You might ask your buddy how his driver enters the corner. JMO.Last edited by oldtrackchamp4x; 09-15-2016, 11:43 AM.
Comment
-
Comment