If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just looking to see if anyone has used the Dandy Pull bar. We are currently running IMCA crate motor with a spring bar, looking to possibly go try a biscuit bar. Any information good or bad would be greatly appreciated
If you have any questions about them please give me a call at 563 659 1153 .I have been selling them for a long time .I can help you out . It is a very nice bar . Thank you Dave
Tweet
Comment