New to modifieds need body help

[Rfisher23]

I have an older model open wheel modified the left back wheel sticks out about 2 inchs and the right back tire sticks out about 4 inchs, i know the imca rules say only 66 inchs, my cars back panel is 65 inchs, How do i get my back wheels tucked up inside the body s i want have to run a nurf bars??? thanks

[Vanhammer]

check your wheel offsets.

[Rfisher23]

the back of the wheel? what kind of wheel do most run?

[dirttrackrocker]

Sounds like someone put a wide rearend in it. Most cars run a 60" rear. You don't have to run nerf bars. IMCA rules say the tires have to be widest part of car on right side, RR can't be under body. Even the nerf bar has to be inside the tire. Left side you can be an inch inside the body or nerf bar if you run one.
Also that 66" is measured at the deck. You can bow the doors and quarters out as long as the tires are the widest part on the Right side.

[Rfisher23]

i mesured the rear end and its 60'' the right rear beadlock rim only has 2 inch back space, should i use a rim with 4 in back space to get the tire closer to car? does all the rims back space have to be the same? such as the left front and left back and the right front and the right back or is each wheel have diff back space??? thanks!!!

[dirttrackrocker]

no set rules on offset. I run 2" everywhere except RR. I switch between a 3 and a 4 on RR depending on conditions.

[Rfisher23]

so it want hurt to have 2inch back spacing on all wheels and have the rr backspacing about 4 inch

[cavemod]

so it want hurt to have 2inch back spacing on all wheels and have the rr backspacing about 4 inch

thats what i run

[Rfisher23]

ok thanks alot!!!!