If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ive recently heard that chassis builders are moving their front springs inboard (towards center of chassis) by about 2"-3".. any truth or thoughts on this?
I have not heard of that. If you use nova lovers on a metric clip they will be at an angle. The chevelle clip are also have a little angle because the spring pockets on the lower a arms are out torward the ball joint.
Tweet
Comment