Tweet
checking to see if the rearend that is in my mod i bought was bent or how bad?. What is the amount of toe out that is acceptable... mine has 1/4 inch toe out measured at the outside of rotor to outside of rotor. Thanks
-
Last edited by ricracer113; 01-17-2011, 10:55 PM. -
I would say around 3/16. It sure is hard on your drive flanges and the carrier bearings on your spool. You can use a mini spool and slide your axles in your hubs and drive flanges and use a press to straighten your housing. -
I would stay around 1/8th inch.if you check it the outter tire dia. it willbe more like 1/2 inch toe out.Comment
-
what the hell was that supposed to mean?Originally posted by 1BlacksheepComment
-
I thought you shouldn't have any, or close to zero.Comment
-
Thats what I'm thinkin !!!
1/4 toe on the rotor , somthins bent 
Torque and flex forces will take some out, but don't think that much. I 've been wrong before tho.
Last edited by 1Blacksheep; 01-23-2011, 08:35 AM.The Blacksheep cometh ! With old bent sh!t that just keeps getting faster !Comment
Comment