Motor Height and front springs

[fastford02]

confused? what did you mean when you said change the rf upper ball joint?

[Confused?]

Changing the ball joints moves the "roll center" up and right or down and left. A taller ball joint on the rf, or a shorter one on the LF should keep the car from rolling over as hard. It's a simple change that can be reversed easily. I prefer a shorter lower on the rf and a taller lower on the LF. Uppers are easier to change, at the track, than the lowers are.

[LateModel B23]

Would raising the motor like has been done to this car require any changes in the back of the car as far as J-Bar location? Frame side, pinion height and/or both?