Pierce modified

[92modracer]

pierce bare chassis. Has stock nova front lower control arms. Can I use Pinto front spindles? Going to run imca. If so what upper and lower ball joints do I use and steering component. Any help would be appreciated. ..thanks

[92modracer]

It is a metric stub. Left that out of my original post. Thanks

[35smod]

Yes you can use them same ball joints you need the taper adapter pierce has them but you use different length upper arms look in the set up book it has the info on them

[35smod]

Sorry you also need bump steer spacers in between the tie rod and spindle

[92modracer]

Ok thanks. On the lower arms. They get reversed right? Rh on left side and lh on right side?

[bob75]

brad if you are using howeball joint you will have to run pierces ball joints, if not i have them on stock.