Cylinder head choice????

[Mosidebite]

Have a 3.80 / 6" rod combo. Going to have to change pistons so that is not a factor. Want a head that can produce good power (750 or more) for half mile and larger tracks and be able to tame down to run a regular 3/8ths once in a while. Any suggestions that will not break the bank?

[go2fast]

heads

you can get 750 hp with 18deg heads or 13deg and get 800 hp +

[Jim11h]

sb2.2 but make sure not a set for talledega or some big track like that

[Egoracing]

What engine block are you running?

[Mosidebite]

little M 4.125 /350 mains is the block. Have been thinking the sb2 stuff. Will not probably turn it more than 8600 if that make a difference

[Mosidebite]

sb2.2 but make sure not a set for talledega or some big track like that

Had not even taken that into consideration, thanks for bringing it up.

[4bangerhotrod]

the sb 2.2 heads will make big hp but theres a reason very few top drivers run them. if any top drivers do i cant think of anybody i know that's running them.

[let-r-eat]

What do you think that reason is?

[Mosidebite]

This engine is not intended to be used in a normal setting. Mile tracks is what it will be used for .

[ptodd]

contact clements racing engines they have the stuff that will run.

[JETAM]

What do you think that reason is?

Obviously, Scott Bloomquist is the biggest name driver that has been successful running Vic Hil SB2's in the past, so they can work. But, I think you don't see them much because the torque curve and acceleration rate of the engine with SB2's is generally not as good as some of the best inline valve heads from Dart or Brodix. The SB2's have a rather high rpm narrow power band whereas the inline valve heads will work better at lower rpm's. The Dart 10-13 degree heads are on many of the fastest professional racers engines. The 9 degree Dart is the lastest head and Brodix is coming out with a new 10 degree head supposedly.

[parrot69777]

What do you think that reason is?

From the drivers I have talked with.....it's a matter of driver preference. Some have said it's too explosive out of the corner and they didn't like the power curve on the straights. While other drivers like the lower RPM torque. Sounds like a great deal when it's tacky but not so good when it slicks off.

[SLM98]

Also the SB2 head on a std block is really hard on lifters.

[JETAM]

Keep in mind also the SB2 is a heavier package to run. The power numbers is not a problem but the package is more expensive to run. Also, by design, the heads generally work better on a smaller cube engine that can operate in the 7-9000 rpm range. Go to you tube and look up East Bay qualifying 2010 with Bloomer and listen to his engine. Then listen to some of the others that can be brought up. He successful with the SB2 because his chassis most of the time have more traction than others and therefore he can slap a lot of gear to his cars with the SB2.

[Mosidebite]

What is the deal with the lifters? Is it the angle in relationship to the push rods or... And for the rpms, it will be about 6500 to 8500 all the time, close enough?
I am sure there are other heads out there that will produce good numbers and be drivable, just looking for something readily available.
Plus since they will be ran no more than 8-10 nights a year they should not require a ton of maintenance or at least I would hope not.