Ford 358

[Mwm60]

Any engine builders recommend good solid roller cam for a ford 358, 14:1 compression, Nheads, Methanol Mod Motor,

Thanks

[sj valley dave]

I would call

Mike Jones
Jones Cam Designs
Denver, NC
jonescams@bellsouth.net

http://www.jonescams.com

(704)489-2449

Thus guy is very good and will listen to what you are looking for...

[let-r-eat]

Crower Part #15481 is a hell of a cam for short tracks. Shaft rockers and valve spring oilers required though if you want to turn it over 7500. That cam will flat make power with that combo.You do have a standard 351 factory block or the Rblock and not the dart right?Jones as recommended would be good to call also.

[Mwm60]

I have the ford svo r block, 4 bolt mains, arp studs, billet crank, eagle h beams, and ross pistons, have shaft rockers, comp camps solid roller lifters,

[let-r-eat]

15481 is a good choice if your 1/4 to 3/8 track.You should be fine with what you have. Good valve springs will be necessary though. PAC is what I would use.