Hei spark problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jsf74
    Senior Member
    • Aug 2011
    • 544

    #1

    Hei spark problem

    I'm trying to fire my motor and loosing spark. I get a good spark for the 1st couple of revolutions and then nothing. I've tried new cap and rotor and swapped modules and it does the same thing. Stumped? I have a multi meter but I'm no guru like some of you guys. It's a DUI hei if it matters.
  • powerslide
    Senior Member
    • May 2007
    • 2696

    #2
    Pin sheared in the dist gear? Chased that for a month once. Didnt do exactly what you described but worth a look.

    Comment

    • Egoracing
      Senior Member
      • May 2007
      • 4852

      #3
      Bad ground on the engine.

      Comment

      • jsf74
        Senior Member
        • Aug 2011
        • 544

        #4
        I think I had a bad coil? It's still fairly new but I swapped in my old junker and it fired right up. Any way to test a coil?

        Comment

        • ToddSmith16
          Senior Member
          • May 2007
          • 2854

          #5
          Check the ground!

          Comment

          • DCM_Doc
            Senior Member
            • May 2007
            • 333

            #6
            Hei

            I just finished working on a friend's 4 wheel drive with a GM HEI. He had replaced the module like you did. I checked & replaced the pickup coil. The engne started but only ran a few minutes till the coil (the main coil in the top of distributor) got hot-I mean HOT! it smoked. The problem was the after market tachometer. I questioned him more & he said the previous coil lasted a few minutes & got hot. I disconnected the tach & replaced the coil & the truck is still running. I had never had this happen before but the problem was clearly the tach. I thought I would pass this on because it took me a while to figure it out.

            Comment

            • 9car
              Member
              • Jun 2012
              • 59

              #7
              did the same thing , finally jumped out the ignition switch and that was it , vibration had gotten to it

              Comment

              • jsf74
                Senior Member
                • Aug 2011
                • 544

                #8
                I forgot about the ign switch. Will have to remember that one.

                Comment

                Working...
                X