Best ideas to keep screw in rocker arm studs in?

[regor]

I have one that seems to keep coming loose. Any ideas in how to keep it tight?

[ToddSmith16]

If the same one is doing it then either the cam lobe is worn down and continues to worsen, inspect the rocker arm may need replaced, stud or lock nut or inset screw is stripped. Check the pushrod also as I'm sure it's taking a beating coming loose all the time.

[usafracer]

I locktight mine in and have zero problems.

[9car]

if the threads are right, no need to put anything on them except sealer . see if the stud will torque to 60-65 ft lbs . I bet it wont do it , if it doesnt, heli coil it or put an insert in it

[regor]

9car, what sealer do you use and how do you torque the studs ?

[9car]

I use a teflon paste (ARP makes some) if the studs go into water jacket , if they dont i just use Moly . take the rocker off, and use a torque wrench , most likely a deep well 11/16" socket

[regor]

I wonder if jb weld for steel would work on the studs threads?