How much rake do you want typically in a modified? 4 bar 4 bar. And what does raising it up and down on the frame side do?
Starting Point: Start with pinion end at: Ford 9" - Center Line of Pinion QC - 1 1/4" to 1 1/2" above pinion center line. Then set rake so left hand frame end is 7" higher than pinion end. Measure from center of attaching bolt to center of attaching bolt. Adjust as needed from there.
Last edited by BigBlueFord; 05-21-2011 at 10:24 AM.
Crewchief #21 Modified Hansen Motorsports 2014 GRT by Phillips IMCA Modified
Yup!! Listen to big blue!
raise it for less body roll or lower it for more body roll
Raise it on Frame side for less body roll??
Originally Posted by dirttrackrocker Raise it on Frame side for less body roll?? Yup. Acts like a kickstand on a bicycle with more angle.
Originally Posted by 28m Yup. Acts like a kickstand on a bicycle with more angle. I am not seeing how this works......can you give some more details on this???
Forum Rules
Bookmarks